Plastic Pipe Shears
Plastic pipe shears for cutting polyethylene, PP-R and other small plastic pipes cleanly and quickly without a saw; two models for pipe up to 63 mm and up to 75 mm.
- Clean, square cuts on plastic pipe
- No swarf and no saw
- Two models: up to 63 mm and up to 75 mm
- Essential tool for fitting compression joints
- Light, one-handed use
Key Specifications
- Product code
- P175
- Unit of sale
- Piece
- Dimensional options
- 2 rows in the specification table
Why pipe shears are needed
The quality of a compression or fused joint starts with the first cut. If the pipe end is cut crooked or rough, the pipe will not go fully into a compression fitting and the chance of a leak rises. Plastic pipe shears with a sharp blade and a holding jaw cut the pipe straight and square and, unlike a saw, leave no swarf.
The shears suit small polyethylene pipe, PP-R pipe, irrigation lateral tubing and other plastic pipes. For larger or thick-walled pipe a rotary or guillotine cutter is used.
Models and tips
Our rows list two models: for pipe up to 63 mm and for pipe up to 75 mm. Choose by the largest diameter you usually cut.
When cutting, seat the pipe fully in the jaw and keep the blade square to the pipe axis. After cutting, chamfer the outer edge slightly so the O-ring of a compression fitting is not damaged. Keep the blade clean and sharp so the pipe is not crushed.
Choosing the right shears for the job
If most of your work is irrigation piping with lateral tubing and PE pipe up to 63 mm, the up-to-63 mm model is lighter and easier to handle. The up-to-75 mm model suits those who sometimes cut 75 mm pipe too; it is a little larger and gives more force.
Cut thick-walled pipe in several stages with even pressure and do not twist the shears, as the blade will bend. In cold weather PE pipe becomes harder; if possible, keep the pipe somewhere warm for a while before cutting.
For pipe larger than 75 mm or very thick walls, use a rotary or guillotine cutter instead of shears so the cut stays square and the tool is not damaged.
Plastic Pipe Shears — Technical Specifications
Wall thickness and weight are calculated from the standard series and are approximate; final values are confirmed in the quotation.
| Max Pipe OD (mm) |
|---|
| 63 |
| 75 |
Plastic Pipe Shears — FAQ
Up to what diameter do the shears cut?
Up to 63 or up to 75 mm depending on the model.
Is it suitable for PE pipe?
Yes, for small PE pipe, PP-R and irrigation lateral tubing.
What tool is needed for large pipe?
A rotary or guillotine pipe cutter.
Why does a square cut matter?
A crooked cut stops the pipe going fully into the fitting and causes leaks.
